EASYLIGHT (Red, Green, White) Night Flying LED Lights (Wire-free) for RC Planes, Drones, Cyclists or similar usage
Install these Easylight Night Flying LED Lights on any RC products or use it for other relevant situations. It has 3 flash modes and glows brightly, increasing visibility at night. Fixed with 1S rechargeable lipo battery, it makes clean installation without unsightly wirings.
Aircraft Navigation Lights Standard
- Red light: left wingtip leading edge
- Green light: right wingtip leading edge
- White light: as far as possible on the tail tip
- Application: RC Plane, Drones, Quadcopters, Helicopter, Cyclists, others
- Last: about 3 hours
- Color: Red, Green, White
- Mode: Double Flash, Single Flash, Breathing
- Switch: Press button by the side to cycle through different modes
- Capacity of the Battery: 3.7V 85mAh LiPo [EASYLIGHT-02]
- Dimensions (L x W x H): 1.85 x 0.51x 0.47 " / 4.7 x 1.3 x 1.2cm
- Weight: about 4.9g (incl. battery)
- Charging: Balance charging of 0.1A
Use the given Micro USB charger board if your own charger could not charge these lights. The micro USB charger board is especially needed if lights are not used for a long time.
Charge the lights using the micro USB charger to revive them. You may use a portable USB charger with the micro USB charger board for ease of use.
1. To protect your RC product's surface, paste protective stickers over desired area.
2. Next, peel off one side of 3M double sided tape, attach it to base of the light.
3. Peel off the other side of tape, stick it onto the protective sticker area.
4. 3M Double sided tape is reusable for a few times. You may keep it in the packaging box after the initial use. Reuse it again when needed.
- 1 x White Light
- 1 x Red Light
- 1 x Green Light
- 1 x Charging Cable
- 1 x Micro USB Charger Board
- 6 x 3M Double Sided Tape
- 3 x Protective stickers